Four (4) grey, cup-shaped replacement gaskets that fit into the current model BriteTap waterer to create a water-tight seal between the waterer and the valves (poultry nipples).
Install As Follows:
1) Remove the BriteTap
from your water supply tank.
2) Place the BriteTap
waterer upside down on a flat surface and remove the valve.
3) Remove the old
cup-shaped grey gasket from the port hole in the BriteTap waterer.
4) Place a new gasket
into the port hole.
5) Screw the valve back
into the port hole that now has a gasket in it. Do this by pressing down while
turning.
6) Use a wrench to make
the last few turns if it is too difficult for you to turn by hand.